The employee’s primary function is the maintenance of equipment at the company’s production facility and customer sites in line with the company’s Health and Safety protocols. This will include but not limited to performing the day-to-day activities and all aspects that are required in the maintenance department. The job scope will include project work for new customer sites.
Planning and Administration
- Ensure all control documents are completed and submitted timeously.
- Daily submission of job cards and vehicle inspections.
- Weekly submission of time sheets.
- Customers sign off of completed site work (emergencies and routine maintenance).
Service and Maintenance
Installation, fault finding and maintenance on mechanical equipment such asRegulatorsHeat exchangersActuated ball valvesNon return valvesHydraulic hosesCouplings and drive gearFlow metersSafety valvesPumpsCompressorsGas generatorsInstallation, fault finding and maintenance on electrical system s and infrastructure such as
AlternatorsMotors, single-phase and three-phaseSwitch gear low voltageFusesLightsSocket outletsInverters / ups on low voltage and extra low voltage control panelsUnderstand and read PLC programs for fault finding and diagnostic on instrumentation to the system.Installation, fault finding and maintenance on instrumentation such as
Pressure transducersThermocouple’sWater and oil level sensorsGas DetectorsVibration SensorsFlowmetersPLC panelsMake use of provided software to fault find, diagnose and setup equipment such as, Power analyzer, Ultrasonic flow meters, Corrector units, DSE deep sea controllers, Ewon, etc.Commissioning of new customer installations.Training
Conduct on the job training for technicians and junior technicians.
Customer training during commissioning of new installations.General
Maintain a neat and organized work environment.
Conduct any other reasonable request by management from time to time.Conduct weekly meter readings and monthly stock take.Maintain spares stock in the vehicle.Keep the company’s equipment in good working conditions.Qualifications Experience / Requirements
Trade tested MillwrightMinimum of 5 years working as a Millwright.SAGA Gas Practitioner license would be advantageous.SACGA Gas Practitioner license would be advantageous.Must have pneumatics, hydraulics, pumps, regulators, power generation, electrical in hazardous areas, instrumentation, mechanical and PLC experience.Minimum of 3 years of cryogenics experience.CNG (Compressed Natural Gas) experience would be advantageous.LNG (Liquid Natural Gas) experience would be advantageous.Computer literacy in MS Excel, MS Word, and MS Outlook.Must have a valid driver’s license.Will be required to work on a shift basis and standby as per operational requirements.Medically fit to work at heights.